aIVR FAQ

ＡThere are three steps : Editing, Compiling and Programming.

ＡWe accept mp3、wav、aif、wma、avi、mpeg.

ＡIt accepts MONO、8BIT、WAV.

ＡBecause you didn’t use our suggest editing software.Usually we suggest use SOUND FORGE、GOLD WAVE、COOL EDIT and so on.

ＡThere will be a little distorted when the voices transfer to our acceptable format. So, we need some editing software to modify the voices to improve the quality. Raising sample rate or using PCM compression will be helpful. If you any further voice quality the request, pls contact our editing engineer [email protected]

ＡYes ! You can mix different sample rate.

ＡNo ! Because their RAMP UP & RAMP DOWN are different, if you do not use your compiling output in your application , it may produce “ Po “ noise before or after you play the voices.

ＡNo ! Because their RAMP UP & RAMP DOWN are different, if you do not use your compiling output in your application , it may produce “ Po “ noise before or after you play the voices.

ＡBecause 8050 transistor belongs to A type amplifier, its high temperature is normal.To avoid this situation happened, we suggest you use APLUS “ AP4890B “ audio power amplifier to improve it.

ＡIf there are any noise existing in the power supply, these noises will be easy through the IC power supply transmit to affect the voice quality. We suggest connect a capacitor between vdd and vss. Becouse of the different circumstances the value of capacitors will be not fixed , but you can try 10uF at first.

ＡThe operating current of the IC itself is about 15mA, if you use” PWM “ to drive speaker directly, the total current will be about 50 ~ 70mA. If you use “ COUT “ add transistor to drive speaker, the total current will be from 120mA to 250mA depends on what speakers & transistors you use.The operating current of the IC itself is about 15mA, if you use” PWM “ to drive speaker directly, the total current will be about 50 ~ 70mA. If you use “ COUT “ add transistor to drive speaker, the total current will be from 120mA to 250mA depends on what speakers & transistors you use.

ＡIC will automatically enter sleep mode after finish playing. So its operating current will be less than 1-5uA.

ＡAll are based on 4bit 6KHz sample rate. It means if you run out all the length, the best sample rate is 4bit 6KHz.

ＡIt depends on your original voices . General speaking, high sample rate has better effect. But, some special voices they need low sample rate instead.

ＡWe suggest 20KHz sample rate is the highest one in every project. If over 22KHz, the IC frequency will be easily unstable.

ＡAccording to our experience, 8KHz sample rate will be accepted by 70% of customers.

ＡNo. But, we can utilize software to transfer MIDI or MELODY to WAV format then we can program them into our OTP.

ＡWe use 8Ohm, 0.25W speaker generally.